Skip to main content

Use the advanced module property filter

Use the advanced module property filter when the hardware behind a diagnostic trouble code (DTC) matters more than the code itself. It can isolate codes reported by modules with a particular part number, manufacturer, or other recorded property.

This task uses the legacy interface

The steps below take place in the legacy Qualifier interface. To get there, set the Next-Gen UI toggle in the top bar to Off. Switch it back to On when you are done.

Illustrated versions of these screens are in Legacy Qualifier.

  1. Open the DTC Manager page.

  2. Click Define. The Define Module Filters dialog opens.

  3. Select a property to filter on.

  4. Click Show available values.

  5. Select the values you want and click Add values.

    Repeat steps 3–5 for as many properties as you need. Your selections collect in the review box so you can check them before applying.

  6. Click Ok.

  7. Back on the DTC Manager page, set the Adv. Module Property Filter radio button to On.

The filter has no effect until you switch it on in step 7.